Skip to main content
Skip table of contents

Using the Scan to Me feature

To send the email to the desired destination, the scan needs to be directed to a specific receiver email address. There are two options to enable the MyQ users to send the scans there: provide them with the respective receiver email address, or predefine these email addresses on the printing device's Web User Interface.

Email addresses for Scan to Me

  • Sending scans to the user's primary email - The scanned document is sent to the user email set in the email text box on the user properties panel.
    The receiver email address has to be email@myq.local.

  • Storing scans to the user's scan folder - You have to create a shared folder and ensure that MyQ has access to this folder. After this, enter the folder's location to the User's storage text box. The scanned document is sent to MyQ, and then stored in the shared folder via the SMB protocol. The stored document file name consists of the user account name, and the date and the time when the scan was sent.
    The receiver email address has to be folder@myq.local.

To enable MyQ to save the scan file in the user scan folder, you have to make sure that the folder is shared over your network and that the computer where you run MyQ has all the necessary access rights to this folder.

Predefined list of the MyQ destinations on the printing device

On the Address List on the printing device's web interface, you can predefine email addresses where the scanned documents are sent to.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.