Skip to main content
Skip table of contents

Communication Security

MyQ runs with secure communication (SSL) by default, but also offers three different certificate authority modes, that can be modified in MyQ, Settings, Network.

On certain devices, selecting Manual Certificate Management mode will mean that certificates cannot be signed.

Built-in Certificate Authority

When using this mode (default), it is required to Generate new CA certificate after the server configuration.

MyQ web UI - communication security

Upload the generated ca-myq.crt certificate from C:\ProgramData\MyQ\Cert on the Sharp device Web UI, in System settings > Security settings > Certificate Management > CA Certificate management.

Sharp web UI - certificate management

Or on older Sharp devices, upload the generated ca-myq.crt certificate from C:\ProgramData\MyQ\Cert on the Sharp Web UI, in Security settings > SSL Settings > Installation of certificate.

Sharp older web UI - certificate installation

It is also needed to modify all the MyQ Server addresses on the device web UI from HTTP to HTTPS, as well as the port you are using on the MyQ Server (8090 by default).

Using custom certificates

In case a custom SSL certificate is uploaded in MyQ, the certificate should also be installed in device web UI and in the Trusted Root Certification Authorities on the server.

Enable unsecure communication

If SSL communication is not required, you can enable unsecure communication (not recommended) in MyQ Easy Config. Go to the Settings tab, under Web Server, enable Allow unsecure communication and click Save.

MyQ Easy Config - Allow unsecure communication

 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.