Skip to main content
Skip table of contents

Before the Installation

Requirements

  • MyQ Fujifilm Embedded terminal 10.2 is supported on MyQ Print Server 10.2+, for optimal use the latest patch is recommended.

  • It is recommended to disable the motion sensor before installation, as it can interrupt setup, consult your individual devices manual to learn how to do so.

  • Put the device into sleep mode prior to installation in order to prevent unexpected issues.

For information about communication protocols and ports, check the MyQ Print Server guide.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close