Skip to main content
Skip table of contents

Connecting MyQ TerminalPro

You can connect the terminal using the below HW connection ports:

HW connections scheme

LAN host (eth0)

LAN port for connecting to the customer's network via network cable

9 pin D-SUB (serial)

Port for connecting a Key Counter cable

USB port

Standard USB port for the card reader connection

Mini-USB port

Mini-USB port for the touchscreen display connection

Power connector (A/C)

Port for the power source connection

  1. Connect the cables to corresponding ports of the terminal:

    1. Network cable to eth0

    2. (Optional) Touch panel cable to Mini/micro USB

    3. (Optional) USB card reader to USB (keep the terminal off when connecting)

    4. (Optional) Key Counter cable to 9 pin D-SUB

    5. Power cable

  2. Wait till the BUSY SESSION STATE indicator glows green (It should take approximately 2 minutes), and then restart the printing device.

After it is connected, the terminal automatically sets up communication with the device. This setup can take a few minutes and after it is done, you need to restart the printing device.

Use cable holders to keep the cables organized and maintain a neat and tidy appearance on the printing device.

Using cable holders
Status indication according to the LED diodes

The MyQ TerminalPro LED diodes provide the following information:

POWER

  • Green light = the terminal is connected to a power source

READY - SERVER STATE

  • Green light = server is online

  • Orange light = no server is set

  • Red light = server is offline

  • Red flashing light = card is being presented to the card reader

BUSY - SESSION
STATE

  • Green light = printing device is in idle state

  • Orange light = printing device is in session

  • Red light = printing device is busy or internal error

ERROR - PRINTER STATE

  • Green light = printing device is online

  • Green flashing light = DHCP protocol is not enabled on the printing device

  • Orange light = Ethernet cable is connected but there is no response from the printing device

  • Red light = no connection (this is not an issue, as the printer should not be directly connected via ethernet to MyQ TerminalPro - it should be connected to the same network via a separate cable)

  • Red light flashes once = diode indicates that the device panel is being unlocked by the key-counter cable

  • Red light flashes twice = diode indicates that the device panel is being locked by the key-counter cable

The below LED diodes should be lit after a correct MyQ TerminalPro setup:

  • Green for the Power diode.

  • Green for the Ready - Server state diode (after setting up the server via MyQ Terminal Manager).

  • Green for the Busy - Session state diode.

  • Red for the Error - Printer state diode (as the printer is not directly connected to MyQ TerminalPro).

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.